RELM PM4500 Manuel d'instructions télécharger pdf (Page 7)

15. Power Up on Channel 1.

The display will show one of the following:

Blinking

3‘

16. Press

TOGGLE

key to toggle Y (Yes) to N (No)

or vice

versa.

If Yes is selected, the Radio will

always be on Channel 1 whenever it is turned

ON (powered-up). If it was in the MANUAL Mode

on Channel 13 (for example) when turned OFF, it

will power-up on Channel 1. If it was in the SCAN

Mode when turned OFF, it will power-up in the

SCAN Mode and start

scanning.

Press

ENTER

to store in memory and advance

the display to TX Carrler Delay.

17. TX Carrier Delay.

Display will show, for example:

Blinking

18. Enter a value 0, 1, 2 or 3. (See Table 3, below.)

TX Carrier Dleay is the amount of time the carrier

(no modulation) is still present

afferthe

Pll

switch is released.

Table 3. Delay Values (mS).

Numeral

Delay

165

300

Numeral

Delay

400

500

Press ENTER to store in memory and advance

the display to Message Annunciator.

19. Message Annunciator.

The

display will show one of the following:

20.

Press

TOGGLE

key to ON or OFF. If ON is

selected, the Message Annunciator feature is

enabled. If OFF is selected, the Message An-

nunciator feature is disabled.

Press ENTER to store in memory and advance

the display to Talk Around.

21. Talk Around.

The display will show one of the following:

Blinking

22.

Press

TOGGLE

key to toggle Y (Yes) to N (No)

or vice versa.

Press ENTER to store in memory and advance

the display to Range.

23. Range.

The display will show, for example:

1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

Commentaires sur ces manuels

Pas de commentaire

RELM PM4500 Manuel d'instructions Page 7

Commentaires sur ces manuels